VENTURA COUNTY, Calif. (KEYT) – On Friday, a 28-year-old Santa Paula man was arrested for multiple gun-related charges after several printed firearms and weapons components were recovered during a search of his home on Santa Barbara Street.
Earlier this month, detectives with the West County Special Enforcement Unit started an investigation into the unlawful production firearms using 3D printing technology stated a press release from the Ventura County Sheriff's Office.
The investigation resulted in the identification of a 28-year-old Santa Paula man and evidence was received that indicated the man was manufacturing 3D-printed weapons at his home and detectives obtained a search warrant for the residence detailed the local sheriff's office.
On Nov. 13, detectives located and detained the 28-year-old before conducting a search of his home in the 1100 block of Santa Barbara Street in Santa Paula where they located a 3D printer, several 3D-printed firearms, a modified assault rifle as well as 3D-printed firearm components and other guns detailed the Ventura County Sheriff's Office.
According to the Ventura County Sheriff's Office, after the search, the 28-year-old was booked into the Ventura County Pre-Trial Detention Facility on charges of unlawful manufacture of an assault weapon, unlawful possession of an assault weapon and manufacturing of high-capacity magazines.
Santa Paula Man Arrested After Multiple 3D-Printed Weapons and Components Seized News Channel 3-12.
Hence then, the article about santa paula man arrested after multiple 3d printed weapons and components seized was published today ( ) and is available on News channel ( Middle East ) The editorial team at PressBee has edited and verified it, and it may have been modified, fully republished, or quoted. You can read and follow the updates of this news or article from its original source.
Read More Details
Finally We wish PressBee provided you with enough information of ( Santa Paula Man Arrested After Multiple 3D-Printed Weapons and Components Seized )
Also on site :